品牌
其他厂商性质
所在地
移动式空气/呼吸空气压缩机
BAUER100
| General |
|
| Medium 介质 | Air 空气 |
| Intake Pressure 进气压力 | Atmospheric 常压 |
| Filling pressure 充气压力 | PN300 |
| Nominal pressure 安全阀压力 | 330 bar |
| Working pressure 工作压力 | 300 bar |
| Permissible ambient temperature range 使用环境温度 | +5...+45°C |
| Permissible altitude 海拔允许范围
| 0...2000 m AMSL |
| Max. permissible tilt 倾角 | 5° |
| System design 外观设计 | Open 开放式 |
| Standard operating voltage 电压 | 220 V; 50 Hz |
| Compressor oil standard 标准压缩机润滑油 | Synthetic 合成油 |
| Oil change interval 换油周期 | Synthetic: every 2 years/ 2.000 h 合成油： 每两年或2000小时
|
| | BAUER100-TW |
| Charging rate 1 流量 | 100 l/min |
| Purification System 过滤系统 | P11/350 |
| Cooling air flow, min. 冷却空气流量要求 | 792 m³/h |
| Sound pressure level 声压 | 86 dB(A) |
| Weight in kg ² 重量 | 45 kg |
| Dimensions (LxWxH) ² 尺寸（长x宽x高） | 860(L)x340(W)x400(H) mm |
1 Measured during cylinder filling from 0-200 bar tolerance +/- 5% at + 20°C ambient temperature.
1.在20℃的环境温度下，将气瓶从0充到200bar时测量
2 Standard model.
2.尺寸和重量为标准设备。
| Drive system | BAUER100-TW |
| Type 驱动 | 1-phase 单相电机 |
| Power 功率 | 2.2 kW |
| Operating voltage / frequency 1 电压
| 220 V, 50 Hz |
| Speed 转速 | 2,850 1/min |
| Protection class 防护等级 | IP55 (TEFC) |
STANDARD SCOPE OF SUPPLY:
压缩机的标准供货范围
Compressor block with following features
压缩机主机有以下特点
■ Splash lubrication
■ 飞溅润滑
■ Micronic intake filter: 10 mm
■ 微尘进气过滤器：10 mm
■ Intermediate coolers, air cooled
■ 中间级冷却器，风冷
■ Aftercooler, air cooled, outlet temperature approx. 10-15 °C above cooling air temperature
■ 末级冷却器，风冷，出口温度比环境温度高10-15度
■ Intermediate separators after each stage (except 1st stage)
■ 每级后中间级油水分离器 （除一级外）
■ Final separator for oil and water condensate after last stage
■ 末级油水分离器
■ Sealed safety valves after each stage
■ 各级安全阀（密封）
■ Pressure maintaining and check valve after the final stage
■ 末级后保压阀及止回阀
| Compressor block |
|
| Charging rate 1 流量 | 100 l/min |
| Speed 转速 | 2,300 1/min |
| Number of stages 压缩级数 | 3 |
| Number of cylinder 压缩缸数 | 3 |
| Cylinder bore 1st stage 一级缸径 | 60 mm |
| Cylinder bore 2nd stage 二级缸径 | 28 mm |
| Cylinder bore 3rd stage 三级缸径 | 12 mm |
| Stroke 冲程 | 24 mm |
| Direction of rotation (from flywheel side) 旋转方向 （从飞轮处看） | Left 左 |
| Drive type 马达连接方式 | V-belt 皮带 |
| Intermediate pressure 1st stage 一级后压力 | 6 - 7 bar |
| Intermediate pressure 2nd stage 二级后压力 | 40 - 60 bar |
| Amount of oil 油池容量 | 360 ml |
| Oil pressure 油压 | 4.5 bar ± 1.5 bar |
1 Measured during cylinder filling from 0-200 bar tolerance +/- 5% at + 20°C ambient temperature.
1. 在20℃的环境温度下，将气瓶从0充到200bar时测量
Purification System P11/350
P11过滤系统
■ Final mechanical separator for the removal of oil-/ water condensate
■ 末级油水分离器，物理分离
■ TRIPLEX long-life filter cartridge processing in 3 stages (drying, neutralization, micro filtering)
■ TRILEX 长效滤芯，处理过程分三个步骤 （干燥；中和；微粒过滤）
■ Final safety valve, fitted to filter housing
■ 末级安全阀，安装在滤筒上
■ Pressure maintaining / non return valve, fitted to filter housing
■ 保压/止回阀，安装在滤筒上
Air quality as per DIN/EN 12021:2014
空气质量根据 DIN/EN 12021:2014
| Contamination 成分 | Maximum content as per 阈值 | Air quality of BAUER 宝华空气质量 |
| H2O 水分 | 25 mg/m³ | ≤ 10 mg/m³ |
| CO 一氧化碳 | 5 ppm(v) | Depending on filter cartridge 1 根据滤芯种类 |
| CO2 二氧化碳 | 500 ppm(v) | Depending on intake air 2 根据进气空气质量 |
| Oil 油分 | 0.5 mg/m³ | ≤ 0.5 mg/m³ |
1 Only with BAUER special filter cartridge with hopcalite and up to a maximum concentration of 25 ppm CO in intake air.
The compressed clean breathing air then contains a maximum of 5 ppm CO.
只有使用宝华带一氧化碳去除剂的特殊滤芯且进气中一氧化碳的含量不大于25ppm
2 The level of CO2 in the intake air must not exceed the maximum level of CO2 as per DIN EN 12021:2014!
进气中的二氧化碳不得超过DIN EN 12021:2014!中规定的二氧化碳的按量
| Purification System 过滤系统 | P11/350 |
| Operating pressure (Standard) 工作压力 （标准） | PN300 |
| Operating pressure max. (PS) 工作压力 | 330 bar |
| Pressure dew point 压力露点 | < -20 °C, equivalent 3 mg/m³ at 300 bar |
| Filter housing volume 滤筒容量 | 0.57 l |
| DGRL 97/23/EG | Vessel category II 压力容器等级 Category II |
| Air purification capacity 空气处理量 (at ambient temperature 20°C and 300 bar)1 环境温度20℃，工作压力300bar时） | 130 m³ |
1 When using a BAUER P11/350 filter cartridge without hopcalite. When using a cartridge with CO-removal the air purification capacity is reduced by ca. 4 %.
当使用不带一氧化碳去除滤芯时的处理量。如果使用一氧化碳去除滤芯，空气处理量减少 4%
Compressor Control
压缩机控制
■ Start/Stop
■ 开/关
■ Overload protection
■ 过载保护
■ Phase protection/Faulty lamp
■ 相序保护/警报灯
Feature
产品特点
■ handles for bottle
■ 气瓶槽设计
■ Comfortable handles for transport
■ 舒适的运输把手
■ Filling device stand
■ 充气手柄插口
PN300 filling device
充气装置PN300
| Filling device | PN 300 |
| Nominal pressure (PN) 设计压力 | 300 bar |
| Valve design 阀设计 | 1 filling valve with integrated ventilation, with German cylinder connector G 5/8" according to DIN EN 144-2 and DIN 477 and manometer, PN300 1 x 带放空功能的充气阀，欧标接口G 5/8" DIN 477, PN 300 压力阀 |
| Filling hose 充气管 | 1 Unimam high pressure filling hose, 1 m length 1 x 高压充气管 1米长 |
All information is given without assumption of liability and subject to technical changes.
宝华保留更改的权利
