丁基钢板腻子橡胶止水带300*10厂家@营口

丁基腻子钢板止水带的生产过程，我们可以先将经过先期处理的镀锌钢带插入橡胶中间硫化成形，两者之间的粘结力的牢固性，具有明显防渗止水方面的效果。中埋式钢边止水带的中间橡胶体在结构变形时被压缩、拉伸、变形，而起到密封止水作用；镀锌钢带与混凝土有着良好的粘附性，不易脱落和松动，使止水带能承受较大的拉力和扭力。在施工中由于混凝土浇筑时的巨大振动力和不易固定，会使普通橡胶止水带产生移位、扯离、扭转而出现松动和脱落，以致在水压较大的情况下会产生渗漏现象，而采用钢边橡胶止水带时，由于钢带与混凝土、钢带与橡胶之间不会产生新的渗漏缝。因此，钢边橡胶止水带增强了结构变形的防渗性能，对整个工程的防渗止水起到了重要的质量保证作用，同时在安装后具有良好的自定性好，克服了止水带需用多方固定的工序，使施工安装更加的方便。
Ding Ji steel putty strip production process, we can first put through pretreatment of galvanized steel inserted into the middle rubber vulcanization forming, strong bonding force between the two, has obvious effect on seepage. Buried steel edged waterstop in the middle rubber body structure deformation by compression, stretching and deformation, and to seal the sealing effect; galvanized steel and concrete has good adhesion, not easy to fall off and loose, so that the water stop can withstand great tension and torsion. In the construction, due to the huge vibration force of concrete pouring and not easy to be fixed, will make ordinary rubber sealing belt, pull off, shifting due to torsion and loosening and dropping, that will produce leakage in water pressure is large, and the steel edged rubber water stop, not because of steel and concrete, steel strip with a new generation of rubber penetration. Therefore, the steel edged rubber water stop enhanced permeability structure deformation, seepage of the whole project has played an important role in the quality assurance, but also has good self good stability after installation, overcome with multi waterstop fixing process, make the installation more convenient.
反应性丁基橡胶腻子带系以一般可伸缩的橡胶和两边配有镀锌钢边所组成的复合件。这种止水带主要靠中间的橡胶段在混凝土变形缝间被压缩或拉伸，而起到密封止水作用。一般来说，混凝土和橡胶的粘附力较差，在常规施工中，又因橡胶是柔软弹性体，使混凝土在浇筑时不易被掏实，故在混凝土接缝膨胀，扯离、扭转时会经常出现橡胶止水带松动和脱落，以致在水头压力较高情况下会产生渗漏现象。对于变形缝大的接缝来说，问题就更为突出。
The reactive butyl rubber putty tape is made of a combination of generally stretchable rubber and galvanized steel edges on both sides. The water stopping belt mainly depends on the rubber section in the middle, and is compressed or stretched in the deformation joint of the concrete, and has the function of sealing and stopping water. In general, concrete and rubber adhesion is poor, in the conventional construction, because the rubber is soft and elastic body, which is not easy to be cut in the concrete pouring, the concrete expansion joints, tear and torsion will often appear rubber zhishuidai loose and fall off, that will produce leakage in the hydraulic pressure under the condition of higher. For seams with large deformation joints, the problem is more prominent.
采用镀锌钢边橡胶复合式止水带，基本上可以克服纯橡胶桥式止水带的这些不足。而且这种复合式止水带还具有双重功能，即一方面可以延长途径，延缓渗水速度，另一方面镀锌钢边和混凝土有着良好的粘附性，使止水带能承受较大的拉力和扭力，从而保证橡胶止水带的混凝土中的有效变形范围内不会产生松动和脱落现象，提高止水效果。钢边橡胶止水带选用镀锌钢边；橡胶：通常选用天然橡胶、氯丁橡胶、三元乙丙橡胶等。要求橡胶和钢边能有效地粘结，它们之间的粘结强度（剥离强度）应达8010N/2.5mm，以使它们在外界条件变化情况下不被拉脱。通常钢边边缘没有工艺孔，安装浇筑混凝土时，利用工艺将止水带和钢边用细铁丝缠绕固定，以保证浇捣密实，使镀锌钢片和混凝土有效地牢固粘附。反应性丁基橡胶腻子带主要用于混凝土现浇时设在施工缝及变形缝内与混凝土结构成为一体的基础工程，如地下设施、隧道涵洞、输水渡槽、拦水坝、贮液构筑物等。
Galvanized steel side rubber composite water stopping belt can basically overcome the shortage of pure rubber bridge water stop belt. And this kind of composite type waterstop also has a dual function, on the one hand can extend the way, slow water penetration rate on the other hand, galvanized steel and concrete edge has good adhesion, the waterstop can withstand greater torque and tension, so as to ensure that the rubber seal is not valid in the range of deformation of concrete mixed with the the loosening and shedding phenomenon, improve the sealing effect. Steel edge waterproof rubber belt adopts galvanized steel edge; rubber: usually choose natural rubber, chloroprene rubber, three yuan ethylene propylene rubber and so on. Requirements of rubber and steel side can effectively bond, the bond strength between them (peel strength) should be 8010N/2.5mm, to make them in the external condition changes are not. Usually, there is no technological hole on the edge of the steel. When installing and pouring concrete, the water stopping strip and the steel edge are fixed by thin iron wires to ensure the filling and compaction of the galvanized steel sheet and the concrete, and the solid adhesive of the dungeon is adhered. The reaction of butyl rubber putty belt is mainly used for cast-in-place concrete when in construction joints and deformation joints and concrete structure has become one of the basic engineering facilities, such as underground tunnels, culverts, dams, aqueducts, liquid storage structures etc..